Revell 23961 Instrukcja Obsługi Strona 11

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 28
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 10
English
English
20
8 CHANGING THE PROPELLERS
If the rotor blades of the multicopter are damaged, they must be replaced.
Proceed as follows:
8A Prior to installation, make sure that you do not mix up the propellers.
The multicopter has 4 different propellers, which differ in colour and direction
of rotation. If the propellers are mixed up, the multicopter will not fly. The two
blue propellers are in front.
8B Unscrew the securing screw of the propeller anti-clockwise from the hub of the
propeller and carefully remove the defective propeller from the shaft.
8C Carefully fit the new propeller on the shaft and carefully screw the securing screw
on again in a clockwise motion.
8D Figure8Dshowsatopviewofthemulticopter.The propellers are marked with a
small 1 or 2 on the underside in the centre. Please assemble as follows:
Flight direction
The rear side of the multicopter is where the battery cable was soldered to the
printed circuit board.
TROUBLESHOOTING
Problem: The propellers do not move.
Cause: •TheON/OFFswitchisinthe"OFF"position.
•Thebatteryistooweakordepleted.
Remedy: •SettheON/OFFswitchtothe"ON"position.
•Chargethebattery.
Problem: The multicopter stops and descends during flight for no
apparent reason..
Cause: •Thebatteryistooweak.
Remedy: •Chargethebattery.
Problem: It isn't possible to control the multicopter using the
remote control.
Cause: •TheON/OFFswitchisinthe"OFF"position.
•Thebatterieswerenotinsertedcorrectly.
•Thebatteriesdonothaveenoughpower.
Remedy: •SettheON/OFFswitchtothe"ON"position.
•Checkwhetherthebatteriesareinsertedcorrectly.
•Insertnewbatteries.
Problem: The multicopter only turns on its vertical axis or rolls over
when started.
Cause: •Incorrectarrangementofthepropellers.
Remedy: •Installthepropellersasoutlinedinthemanual.
Problem: The multicopter won't fly a looping manoeuvre.
Cause: •The3-stageswitchisnotsetto100%,batterytooweak.
Remedy: •Pressthe3-stageswitchallthewaytotheright,chargethebattery.
Additional tips and tricks can be found online at www.revell-control.de.
Black 2 centre left
Black 1 centre right
Blue 1 front left
Black 2 right rear
Blue 2 front right
Black 1 rear left
20 21
www.revell-control.de
SERVICE NOTES
Go to www.revell-control.de for ordering information
and tips on replacing spare parts, plus other useful
information on all Revell Control models.
Przeglądanie stron 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Komentarze do niniejszej Instrukcji

Brak uwag